Table of Contents

8.19 BCM: (Enable/Disable)

Centurion Super Pro

Enable and Disable features of the BCM.
NOTE: If the ECU is locked by another product, you will NOT be able to perform any active settings changes as we will not be able to communicate with the ECU.
  1. Select the Active Settings Icon ( )
  2. In the first dropdown menu select 'TSM-TSSM-HFSM-BCM'
  3. In the second dropdown menu select 'BCM: (Enable/Disable)'
  4. Press the 'Start' button next to the BCM feature you wish to Enable or Disable.
  5. Select 'Enable' or 'Disable' button and press 'OK'.
  6. Wait for confirmation (PASS / FAIL / NA).
Some of these features are limited to certain model motorcycles and certain ECUs.
ABS Installed
This feature is used for when you have a new BCM and a ABS system gets installed, by enabling this you are telling the BCM to recognize the new ABS system.
Radio Installed
This feature is used for when you have a new BCM and a radio system gets installed, by enabling this you are telling the BCM to recognize the new radio system.
Service Mode
This feature will allow you to put the motorcycle into service mode, this needs to be done to allow you to properly work on a motorcycle without having the security system alarm go off.
Side Car (Trike Kit)
This feature is used for when you are installing and turning a motorcycle in to a trike. Just enable, to allow the motorcycle to recognize that it is a trike.
Switchless
By enabling this feature you are making the motorcycle switchless. This means that the motorcycle will work like a CVO model, meaning that if you enable switchless you will disable the ignition switch allowing you to only use the start/stop button.
Fork Lock
If you have a fork steering lock system installed on your motorcycle, you can enable it in our software to allow the feature to be used. This is system is used as security for your motorcycle to prevent someone from stealing it. If you have a fork lock system installed on your motorcycle, make sure the system is enabled in the BCM so that it can be utilized properly.
Power Lock
If you have a power lock system installed on your motorcycle for the saddlebags and such, you can enable it in our software to allow the feature to be used.